OPTICAL FIBER CABLE TESTING AND TERMINATION

image

OPTICAL FIBER CABLE TESTING AND TERMINATION

The customer for a fiber optic cable installation will require documentation of test results before accepting and paying for the work. This obviously leads to certain but often conflicting requirements on the part of the contractor doing the installation. Testing takes time, so completing all the tests in the minimum time means more profit. Testing, however, needs to be done carefully to ensure the measurements are accurate1, and that can take time. Accurate testing, however, will ensure that no good cables are rejected and no bad ones missed, so the contractor will not have to repair what are really good cables and get callbacks on bad ones.

KMCE Provides splicing technicians to work together with sophisticated equipments to enhance productivity and maximize cost efficiency.

Expert Fusion and Mass Fusion Splicing of OFCs

Standard, Single Mode and Multi Mode OFCs

Active Hot Cut Splicing of OFCs Transition and Termination Splicing of OFCs

KMCE implements the most sophisticated software and testing equipment in the market and can test and document systems by the Power meter and the OTDR method. Clients can be provided data from both directions at any wavelength.  Pre-Placement and Post-Placement Testing

Testing via OTDR and Power Meter End to End Insertion Loss & Attenuation Analysis
 

 

If You Need Any Industrial Solution ... We Are Available For You

Contact Us